Product Overview
M-Factors 2.5" 32GB/64GB SATA MLC SSD
M-Factors 2.5" 32GB SATA SSD delivers all the advantages of Flash Disk technology with Serial ATA I/II/III interface and is fully compliant with the standard 2.5" form factor. The device is designed based on the standard 7-pin interface for data segment and 15-pin for power segment. The 2.5" SATA runs at a maximum operating frequency of 300MHz with 40MHz external crystal. Based on Toshiba's MLC flash (with external DDRIII 256MB/512MB cache enabled and measured by CrystalDiskMark v3.0), Emperor 900 can reach up to 450MB/s read as well as 300MB/s write high performance. Moreover, the 2.5" SATA SSD enables hot-swapping when removing, replacing, or upgrading flash disks while also providing low power consumption in comparison to traditional hard drives.
Offering improved Read/Write performance, SMART technology, reliability, and low power consumption, E911 2.5" SATA SSD is an ideal storage for embedded systems.
HIGHLIGHTS
- Easy installation
- Toshiba MLC NAND Flash
- Compliant with SATA Revision 3.0
- Compatible with SATA 1.5Gbps, 3Gbps, 6Gbps interface
- NCQ support up to queue depth=32
- Supports power management
- Supports expanded register for SATA protocol 48 bits addressing mode
- Embedded BIST function for SATA PHY for low cost mass production
- Supports all types of MLC large block: 16K/page NAND Flash
- Supports 2.3 interface and 3.0 interface: 5 channels at maximum
- Contains 4pcs to 16pcs of TSOP Flash
- Corrects up to 72bits error in 1K Byte data
- Supports SMART and TRIM Commands
***Optional Industrial Grade supporting -45C to 85C and SLC is available (Contact 949.617.0080 or support@mfactors.com)
Item |
Specification |
||
Specification |
Interface |
SATA 6Gbps and 3Gbps, 1.5Gbps interface ONFI 2.3 and ONFI 3.0 Interface support |
|
Electrical | 5V (Operating Voltage) | ||
Form Factor |
2.5" SATA |
||
SIze |
Option 1: 100mm*69.85mm*7mm Option 2: 100mm*69.85mm*9.5mm |
||
weight |
~2oz/0.13lbs |
||
Capacity |
32GB |
||
Performance |
Sequential write |
300 MB/s |
|
Sequential Read |
450 MB/s |
||
Power Dissipation |
Idle |
105mW |
|
Active |
2560mW | ||
Dependability |
TRIM |
support | |
NCQ |
support | ||
Firmware Update |
support | ||
MTBF |
>1,000,000 hours |
||
S.M.A.R.T |
support |
||
Bad-Block Management |
Advanced bad sector management algorithms |
||
Wear-leveling |
Static and dynamic wear-leveling algorithms |
||
ECC |
Built in hardware ECC circuit (up to 72bit/1KB) |
||
Environment |
Storage temperature |
-40~85℃ |
|
Operation temperature |
Standard |
0~70 ℃ |
|
|
|||
|
|||
Vibration |
80Hz~2000Hz/20G | ||
Shock |
1500G/0.5ms |
||
Humidity |
90% under 40C |
||
TBW |
Terabytes Written: 35TBW for 32GB |
RoHS Compliant |
Yes |
Warranty |
2 years |