Emperor 600 MO297 Half Slim SATA Solid State Drive

Emperor Disk proudly introduces the MO297 Half Slim SATA solid state drive (SSD).

Emperor 600 Half Slim SATA SSD delivers all the advantages of Flash Disk technology with Serial ATA I/II/III interface and is fully compliant with the standard Half Slim form factor, JEDEC MO-297. It is designed to run at a maximum operating frequency of 300MHz with 40MHz external crystal. Available capacity ranges from 8GB to 256GB. Based on Toshiba's A19nm Toggle MLC flash (with external DDRIII 256MB/512MB cache enabled and measured by CrystalDiskMark v3.0), Emperor 600 can reach up to 525MB/s read as well as 380MB/s write high performance. Moreover, the power consumption of the Half Slim SATA is much lower than traditional hard drives.

Offering improved Read/Write performance, SMART technology, reliability, and low power consumption, Emperor 600 MO297 Half Slim SATA SSD is an ideal storage for embedded systems.

HIGHLIGHTS

• Easy installation
• Toshiba A19nm MLC
• Compliant with SATA Revision 3.0
• Compatible with SATA 1.5Gbps, 3Gbps, 6Gbps interface
• NCQ support up to queue depth =32
• Supports power management
• Supports expanded register for SATA protocol 48 bits addressing mode
• Embedded BIST function for SATA PHY for low cost mass production
• Supports all types of MLC large block 16K/page NAND Flash
• Supports ONFI 2.3 and ONFI 3.0 interface: 5 channels at maximum
• Contains 4pcs of TSOP Flash
• Corrects up to 72bit error in 1K Byte data
• Supports SMART and TRIM Commands

 ***Optional Industrial Grade supporting -45C to 85C and SLC is available (Contact 714.460.9844 or support@mfactors.com)