Product Overview
Emperor 480 M.2 (NGFF) 2280mm SATA SSD
Emperor Disk proudly introduces Emperor 480 M.2 (NGFF) 2280 solid state drive (SSD) for many of today's Tablets, UltraBooks, Hybrids, NUC and Desktop PCs.
Emperor 480 M.2 2280 SSD delivers all the advantages of Flash Disk technology with Serial ATA I/II/III interface and is fully compliant with the standard Next Generation Form Factor (NGFF) called M.2 Card Format (generated by Intel). Available capacity ranges from 16GB to 256GB. The module runs at a maximum operating frequency of 300MHz with 40MHz external crystal. Based on Toshiba's 15nm MLC flash, Emperor 480 can reach up to 560MB/s read as well as 380MB/s write high performance. Moreover, the M.2 2280 SSD provides lower power consumption in comparison to traditional hard drives.
Offering improved Read/Write performance, SMART technology, reliability, and low power consumption, Emperor 480 M.2 2280 SSD is the best embedded solution for new platforms.
HIGHLIGHTS
- Easy installation
- Toshiba 15nm MLC, Toggle 1.0 and Toggle 2.0
- Compliant with SATA Revision 3.0
- Compatible with SATA 1.5Gbps, 3Gbps, 6Gbps interface
- Supports power management
- Supports expanded register for SATA protocol 48 bits addressing mode
- Embedded BIST function for SATA PHY for low cost mass production
- Supports all types of MLC large block: 8KB/page and 16K/page NAND Flash
- Supports ONFI 2.3 and ONFI 3.0 interface: 4 channels at maximum
- Contains 1pc to 4pcs TSOP flash
- Corrects up to 72bits error in 1K Byte data
Optional Industrial Temp supporting -40C to 85C is available. Contact support@mfactors.com
Item |
Specification |
||
Specification |
Interface |
SATA 6Gbps and 3Gbps, 1.5Gbps interface ONFI2.3 and ONFI 3.0 Interface support
|
|
Electrical | 3.3V (Operating Voltage) | ||
Form Factor |
M.2 (NGFF) 2260 |
||
Size |
80mm*22mm*3.8mm |
||
Weight |
~7grams/0.015lbs |
||
Capacity |
16GB~256GB (support 48bit addressing mode) |
||
Performance |
Sequential write |
380 MB/s |
|
Sequential Read |
560 MB/s |
||
Power Dissipation |
Idle |
310mW (Active 1960mW) |
|
DEVSLP |
5mW | ||
Dependability |
TRIM |
Support | |
Over-Provision |
Support | ||
Firmware-Update |
Support | ||
MTBF |
>2,000,000 hours |
||
S.M.A.R.T |
Support |
||
Bad-Block Management |
Advanced bad sector management algorithms |
||
Wear-leveling |
Static and dynamic wear-leveling algorithms |
||
ECC |
Built in hardware ECC circuit (up to 72bit/1KB) |
||
Environment |
Storage temperature |
-40~85℃ |
|
Operation temperature |
Standard |
0~70 ℃ |
|
Industrial |
-40~85 ℃ |
||
|
|||
Vibration |
80Hz~2000Hz/20G | ||
Shock |
1500G/0.5ms |
||
Humidity |
90% under 40C |
||
RoHS Compliant |
YES |