E910 2.5" SATA (WITH optional pFAIL Power Loss Data Protection) 

Emperor Disk proudly introduces the 2.5" SATA (with 32-Bit Quad-Core CPU) solid state drive (SSD). Emperor 910 is a high-performance, quad-core controller that delivers all the advantages of Solid State Drives technology of Serial ATA interface. Supporting up to 8-channels and 64 CE in its NAND Flash interface, it is possible to achieve up to 550 MB/s of Sequential Read and 530MB/s of Write performance and up to 100,000 IOPS at Random Read. 

Emperor 910 delivers all the advantages of Flash Disk technology with Serial ATA I/II/III interface and is fully compliant with the standard 2.5" form factor, provides low power consumption compared to traditional hard drives and it enables hot-swapping when removing/replacing/upgrading flash disks. The device is designed based on the standard 7-pin interface for data segment and 15-pin for power segment. Emperor 910 2.5" SATA runs at a maximum operating frequency of 300MHz with 40MHz external crystal. Available capacity ranges from 128GB to 2TB. Moreover, the SSD can reach up to 550MB/s as well as 530MB/s write high performance based on Toshiba's 15nm Toggle MLC flash (with 256MB/512MB DDR3 cache enabled and measured by CrystalDiskMark v3.0).

Offering improved Read/Write performance, SMART technology, AES256, End-to-End data protection, low power consumption and optional pFAIL circuitry, Emperor 900 2.5" SATA SSD is an ideal storage for embedded systems.

HIGHLIGHTS

• Easy installation
• 32-Bit Quad-Core CPU
• Random Read/Write: 100K/90K IOPS
• SmartECC- RAID ECC protection
• End-to-End (ETE) Data Path Protection
• Toshiba 15nm MLC NAND Flash
• Write Protect Option
• Optional pFAIL circuitry
• Compatible with SATA 1.5Gbps, 3Gbps, 6Gbps interface
• Supports all types of MLC large block: 8KB/page and 16KB/page NAND Flash
• Supports ONFI 3.2 interface: SDR and NV-DDR up to mode 5, NV-DDR2 up to mode 7
• Contains 1pc to 16pcs of TSOP Flash
• Corrects up to 120bits error in 2K Byte data
• Supports SMART and TRIM Commands

Optional Industrial Grade Temperature -40°C to 85°C is available

 (Please contact 714-460-9844 or support@mfactors.com)